Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.
TF-LC02 LiDAR module, ToF, UART, 3.3V
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
LiDAR module, TF-LC02, compatible Arduino and other development boards, based on the ToF (Time-of-Flight) principle and TDC (Time-to-Digital Converter) architecture, which allows distance measurement with very small dimensions. It is specially designed for intelligent robots, drones and smart home appliances, this module provides fast and reliable measurements.
It supports UART communication and is equipped with a 6-pin PH1.0 connector for quick connection and mounting lugs for stable mounting.
Specifications:
Supply voltage: 3 -3.6VDC
Average current consumption: ≤15mA
Logic voltage: 3.3V
Operating range: 3cm ~ 200cm (90% reflectivity)
High accuracy: ±2cm (3cm ~ 100cm), ±5% (100cm ~ 200cm)
Data acquisition time: 33ms
Light source: VCSEL (Vertical cavity emitting laser)
Photobiological safety: Class 1 (according to IEC60825-1:2400)
UART communication: Signal level LVTTL (3.3V)
Low power consumption: ≤50mW, with an average current of ≤15mA
Viewing angle: ±9° (theoretical)
Operating temperature: -20℃ ~ 70℃
Module dimensions: 20mm × 11.5mm × 7.6mm
Optical parameters:
Central wavelength: 940nm.
Photobiological safety: Class 1.
Electrical parameters:
Use:
Pinout:
VCC (3.3V) – Power supply (red wire)
GND – Ground (black wire)
Lidar RX (Pin 1 / TX) – Data reception (green wire)
Lidar TX (Pin 0 / RX) – Data transmission (yellow wire)
CS (Control Select) – Connected to ground (blue wire)
