GPS and GNSS Modules

GPS receiver with RS232 output and NMEA 0183 messages, ideal for navigation, monitoring and time synchronization in industrial and maritime systems. It offers 1 Hz update, 66 channels with GPS QZSS support and SBAS corrections for an accuracy of about 2 m, has an active antenna integrated in an IP67 enclosure and is powered at 5 V, with a 2.5 m shielded cable for quick connection.

Multi-constellation L1 GNSS solution for fast integration on TTL UART, provides stable positioning in mobile and industrial applications. Supports GPS, GLONASS, Galileo, BeiDou, QZSS and SBAS for faster fix in difficult areas, allows up to 25 Hz update for dynamic tracking, includes 1PPS output for precise synchronization and saves settings in Flash.

Compact module for FPV drones and DIY projects, offers fast and stable positioning with simultaneous GPS, GLONASS, Galileo and BeiDou reception, up to 5Hz update via UBX for better response in flight, integrated QMC5883L compass on I2C for precise orientation, PPS LED easily indicates 3D fix status, includes 15x15 mm patch antenna for easy mounting.

Professional GNSS RTK solution for stable centimeter-level positioning, ideal for automation, drones, measurements and monitoring in urban environments. Dual band L1 L5 reception with multi-constellation tracking GPS GLONASS Galileo BDS QZSS, high sensitivity with integrated SAW and LNA for interference resistance, UART I2C SPI interfaces and NMEA RTCM support. Includes YEGB000Q1A antenna.

The original NEO-M8N GPS module with integrated compass for Pixhawk and PX4, offers fast satellite fix and precise navigation for stable flights. It comes pre-configured and tested from the factory, ready to use immediately, includes SAW filter and active interference detection for cleaner signal in difficult environments, and the compact design with self-adhesive sticker allows for quick and secure mounting.

GPS module for location, navigation and telemetry projects, with u-blox 7 receiver and active 25x25 mm ceramic antenna on u.FL for flexible mounting. It provides coordinates, altitude, speed, satellites and UTC time in NMEA at 9600 baud, via UART TTL compatible with Arduino, ESP, STM32 and Pico. 3-5V power supply for 5V and 3.3V boards, backup battery for faster fix, LEDs for power and GPS fix.

GPS module compatible with Arduino and other development boards, ideal for quickly integrating satellite positioning into DIY and industrial projects. It offers serial communication at 9600 bps, ceramic antenna for stable reception, EEPROM with backup battery for data retention during power outages, and an integrated 3.3V regulator for direct operation at 3-5V.

Development board for communications and localization, ideal for IoT and telemetry projects. It offers quad-band GSM GPRS, precise GPS with fast fix, and Bluetooth, with control via AT commands over UART with autobaud. The UART logic level is selectable at 1.25V, 3.3V, or 5V via VMCU, compatible with Arduino, STM32, ESP32, and Raspberry Pi. Includes GSM and GPS antennas.

Ideal for IoT projects and mobile devices, it offers GSM GPRS connectivity for SMS calls and data, plus dual mode GPS BDS location. Includes integrated charging for 3.7V Li Ion battery, microphone and speaker interface for audio, USB for communication, TF slot and accelerometer for motion detection, compatible with AT commands.

Complete set for autonomous drone control, compatible with official ArduPilot and PX4 firmware, with 32bit ARM Cortex-M4 processor for fast and stable response, 14 PWM outputs and UART I2C SPI CAN interfaces for flexible integration. Includes M8N GPS for precise positioning, microSD for logs, buzzer, PPM encoder, I2C splitter, cables and stop button.