Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.
Power Mosfet Module, 3D Printers, 12-24V, 25A
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
External power mosfet for 3D printers, 12VDC or 24VDC voltage, 25A maximum.
This transistor module is specially used for the heated bed of the 3D printer to power it from a more powerful external source. In this way, the bed will still receive a signal from the printer's motherboard, but it will be powered externally.
It is recommended to use an external module for the printer bed because it, being the biggest current consumer, will no longer force the motherboard, it will work at much lower temperatures, and will greatly extend its life. The module is also a must if, for a better and faster heating of the printing bed, you want to switch from 12V to 24V or increase the current. It can also be used on the extruder, although it is not a necessity, since it is not as big a consumer as the bed.
Specifications:
Input voltage: 12 - 24VDC
Maximum current: 25A (in case of overheating, requires active cooling)
PID control: Yes
Dimensions mm: 50 x 60mm
