Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.
MKS Gen V1.3 Motherboard, Ramps 1.4, 3D Printer
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
The v1.3 motherboard is a development board used to control 3D printers. This joins the MEGA2560 plus Ramps 1.4 board into a single board, eliminating the problems derived from using two separate boards.
Supports a maximum of 5 fully replaceable stepper motor drivers. It is compatible with A4988, DRV8825 and TMC2100 drivers.
The PCB is of quality, composed of four layers, and made with an efficient heat dissipation in mind due to the use of better MOSFETs.
It uses a dedicated integrated power supply that accepts voltages of 12VDC or 24VDC, which is why, with the same board, you can switch to 24VDC, benefiting from lower mosfet temperatures due to the need for a lower current.
The board can directly replace the Mega2560+Ramps 1.4 assembly, the Marlin firmware settings being identical to those for Ramps 1.4.
Supports connection for a 2004 and 12864 LCD control panel with SD card.
It also allows connecting motors from an external motor source.
Drivers are not included.
Specifications:
Supply voltage: 12V - 24VDC
Processor: ATMega2560
