Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.
Round LCD display module, 240x240, 1.28 inch, 3.3V, SPI
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
1.28 inch TFT display, compatible with Arduino and other development boards, being an LCD display module that offers a vibrant resolution of 240x240 pixels.
It is equipped with the GC9A01 driver chip and a 4-wire SPI interface, offers full RGB colors and supports a wide range of voltages from 3 to 5V. With IPS technology, you have a complete perspective, regardless of the angle from which the display is viewed.
Specifications:
Supply voltage: 3 - 5VDC
LCD size: 1.28 inches
Usable screen diameter: 32.4mm
Resolution: 240x240
Driver Chip: GC9A01
Interface mode: SPI
Color: Full RGB
Outlook: Full IPS
Operating temperature: -20 to 70°C
Storage temperature: -30 to +80°C
Dimensions: 45.5 x 38 x 23mm
Definition Pins:
1 - VCC: Power supply
2 - GND: Power ground
3 - SCL: Clock for the serial interface
4 - SDA: Input/output pin for the SPI interface, data is left on the rising edge of the SCL signal.
5 - DC: Data/command selection pin in the 4-line serial interface.
6 - CS: Chip selection pin: active when low, disabled when high.
7 - RST: This signal resets the device and must be applied to correctly initialize the chip, active low level signal.
Use:
To test the display, you can use the Adafruit_GC9A01A library, available on Github.
