Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).
XY-WT01 Temperature Controller Digital LED Display Regulator Thermostat Switch
Specificatii:
Set Temperature --SetT; Backlash Temperature--BackT
1.Heating Mode H：
When Temperature ≤ SetT – BackT;Relay conduction, heating equipment begin to work;
WhenTemperature≥ SetT,Relaydisconnect, heating equipment stop work;
2.Refrigeration mode C：
When Temperature ≥ SetT+BackT;Relay conduction, refrigeration equipment begin to work;
When Temperature ≤ SetT;Relay conduction, refrigeration equipment stopwork;
3.High Temperature Alarm ALA：
When Temperature≥ AlarmTemperature,The system opens the sound and light alarm, and disconnects the relay, any key stops the sound light;
4.Delay Start OPH：
When a normal heating or refrigeration work is done, the system starts to time T, and only after the T≥OPH, the system can carry out the next round of heating or refrigeration work;
5.Temperature Correction Function OFE(-10.0 ~ 10.0℃)：
The system will work for a long time and may have deviations that can be corrected by this function,Temperature = Measured + Calibration；
6.Parameter Remote Read/Set：
The parameters such as setting temperature, backlash temperature and temperature correction can be set through UART.
7.Real-time Temperature Report:
If the temperature reporting function is turned on, the product is transmitted to the terminal by the UART at 1s intervals, which facilitates data collection;
8.Relay enable (default enable):
If the relay is disable, the relay remains disconnected
feedback Report comment