Digital LED Display Time Delay Relay Module Board DC 12V

Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.

Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).

Digital LED Display Time Delay Relay Module Board DC 12V

Cere Cotatie

Descriere

Specificatii:

Working voltage: DC12V (normal operating voltage DC10V-16V)

Source: DC4V ~ 20V (positive trigger common power button, PNP sensors, PLC signals, etc.)

Output capability: You can control the DC or AC 220v5A within 30v5A within

Quiescent Current: 20mA,

working current: 50mA

Life: more than 10 million times;

Working temperature: -40 ~ 85'C;

Weight: about 26g

Dimensions: 64.2mm * 34.8mm * 18.5mm

Features: anti-reverse voltage input circuit, worry- wiring. Signal input optocoupler isolation, anti-interference ability. Set the parameters of power and permanent memory. Powerful flash MCU online programming capabilities, according to user needs can contact the manufacturers to customize the functionality.

Receives a trigger signal to start the countdown, while the relay, timing the end of the relay to stop working, time to recover to the set, waiting for the next trigger.

Instructions:

Click K1 enter the time setting, one hundred digital start flashing, then press K2, one hundred the number of changes; then click K1 ten digital start flashing, then press K2, the tens digit changes; then click K1 bit digital start flashing, then press K2, single-digit change; then click K1, exit the setting, LED no longer flashes.

Normal digital tube display, press K2, shifting the decimal point, a decimal point indicates 0-999 minutes in 10 bit from 0 to 99.9 seconds with no decimal point represent 0-999 seconds; to this time setting is completed.