6V 12V 24V Wireless Remote control Switch 2CH Relay Module Receiver EV1527 RF Transmitter 433Mhz Remote Controls motor
zoom_out_map
chevron_left chevron_right

Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.

Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).

6V 12V 24V Wireless Remote control Switch 2CH Relay Module Receiver EV1527 RF Transmitter 433Mhz Remote Controls motor

54.40 RON Tax included 45.71 RON (tax excl.)
Tax included

Specificatii:

1. Working Voltage:DC12V

2. Quiescent Current:5mA

3. Working Frequency:433Mhz

4. Receiving Sensitivity:-104dBm

5. Function option:Momentary/Toggle

6. Modulation Mode:ASK

7. Matching Mode: Intelligent Learning code

8. Output Mode:Dry contact /Voltage output

9. Shell:Yes

10. Working temperature : -30~+80

11. PCB dimension:68.2x48.2(mm)

Deleting existing remote controls data:

Press the learning button on the receiver 8 times;

the existing data on the receiver will be cleared. (Note that data cleared means all the paired remote control will have to re-paired in order to control the receiver relay)

Momentary Mode:

Press the learning button on the receiver once, Led (on the receiver board) switches off.

Press "A button", then press "B button", Led (on the receiver board) switches on, momentary mode successfully set up.

Toggle Mode:

Press the learning button on the receiver twice, Led (on the receiver board) switches off.

Press "A button", then press "B button", Led (on the receiver board) switches on, toggle mode successfully set up.

Toggle Mode 2:

Press the learning button on the receiver 3 times, Led (on the receiver board) switches off.

Press "A button", then press "B button", Led (on the receiver board) switches on, toggle mode 2 successfully set up.

chat Recenzii (0)
Produse vizualizate recent