Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).
12V One 1 Channel Relay Module Board Shield with optocoupler Support High and Low Level Trigger
Specificatii:
1, The module uses genuine quality relay , normally open interfaces Maximum load : AC 250V/10A, DC 30V/10A; 2, Using SMD optocoupler isolation , driving ability , stable performance ; trigger current 5mA; 3,The module voltage is 12 V are available ; 4,The module can be set to high or low triggered by jumper ; 5,Fault-tolerant design , even if the control line is broken , the relay will not operate ; 6,The power indicator ( green ) , relay status indicator ( red ); 7,Interface design humane, all interfaces can be connected directly via terminal wiring leads , very convenient; 8,Module size : 50mm * 26mm * 18.5mm ( L * W * H ); 9,Has four mounting bolts holes , hole 3.1mm, 44.5mm * 20.5mm pitch. Two module interface : 1, DC +: Positive power supply ( voltage required by the relay , there 12V choice ); 2, DC-: Negative power connection; 3, IN: Can be high or low level control relay. Relay outputs : 1, NO: Normally open relay interface, the relay before the vacant after the pull shorted with COM; 2, COM: Common Interface Relays; 3, NC: Normally closed relay interface relay shorted with COM ago , after the pull- vacant. High and low trigger selection ends :1 short jumper with LOW LOW triggered when connected ; 2 When the jumper is high with high short trigger . Package Included: 1 x Relay Module with Optocoupler
feedback Report comment