Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).
DIY KITS 6J1 Tube Preamp Amplifier PreAmplifier Board Pre-amp Headphone Amp 6J1 Valve Preamp Bile Buffer Diy for Amplifier
Specificatii:
Size:77*75*52mm
Sound channel type: 2.0/ stereo
Power input: AC AC12V, 0.8A, /5.5*2.5 plug
Knob function: power switch / volume adjustment
An open power tube filament heating is started,when the boost from the zero-voltage start boosting hot filament tube,etc.,also happens to boost boosting finish,so this is the same with the guts rectification.8*470UF the capacitor filter very clean,good power supply system will not have a hum,the filament is 12V DC power supply,need two filament tube is connected in series with a DC filament also in order to reduce the noise.
AC 12V Input:
Need to use AC 12V power adapter. If using a plugless AC 12V transformer, need to solder the connect line to the board. Remember: Can not use the DC power input, otherwise it does not work!
L/R channel input:
Audio signal input, can be connected to the phone, computer, M3, MP4, and other music players.
L/R channel output:
Audio signal output, can be connected to the audio signal input of amplifier, amplifier board,Provide full music enjoyment to the post-amplifier!
The power switch / volume knob:
Turn the knob counterclockwise just start to reduce the volume, when the volume off to the minimum, if you continue to rotate until the "tick" sound, then the power is off, the light goes out; In the closed state, turn the knob clockwise, hear the "click", the indicator light is on, that power is turned on, the volume is the smallest, and then continue to clockwise rotation is to increase the volume.
This tube preamp is a circuit schematic design fake name X10-D fax machine music, to be rational optimization, more stable performance than the original machine, tube play a ten percent increase.
This machine uses a single 12V AC input, the circuit processing provides 6J1 tube needed positive and negative voltage and filament power supply voltage.
FE-6J1-2 fever tube pre-amp board is the circuit schematic design imitation crew Music fax X-10D,to be rational optimization,more stable performance than the original machine,tube play 10percent increase. This board uses a single 12V AC input,the circuit processing provides 6J1 tube needed positive and negative voltage and filament power supply voltage.
feedback Report comment