Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).
SW-520D Angle sensor module/Tilt sensor module ball switch / vibration switch
Specificatii:
1.Using the highly sensitive angle switch SW-520D as the sensor.
2. Comparator output, clean signal, good waveform, strong driving ability, more than 15mA.
3. Working voltage 3.3V-5V
4. Output form: digital switch output (0 and 1)
5. With fixing bolt holes for easy installation
6. Small board PCB size: 3.2cm x 1.4cm
7. Use wide voltage LM393 comparator
Module instructions
1. For the wiring of this module, please see the wiring diagram below for detailed instructions;
2. The switch output of the module depends on the on and off of the angle switch. When the angle switch is off, DO outputs high level, and when the angle switch is on, DO outputs low level;
3. The output terminal can be directly connected with the single-chip microcomputer, and the high and low level can be detected by the single-chip microcomputer, thereby detecting the angle change;
4. The output terminal can directly drive the relay module, which can form a high-power angle switch to protect electrical equipment and other products from automatically powering off when they fall.
feedback Report comment