Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).
STM32F103C8T6 ARM STM32 Minimum System Development Board Module
Specificatii:
l Core: ARM 32-bit Cortex ™ -M3 CPU
− Operating frequency up to 72MHz
− Single cycle multiplication and hardware division
l Memory
− Flash program memory from 64K or 128K bytes
− RAM up to 20K bytes
l Clock, reset and power management
− 2.0 ~ 3.6V power supply and I / O pins
− Power-on / power-off reset (POR / PDR), programmable voltage monitoring
Device (PVD)
− 4 ~ 16MHz crystal oscillator
− Built-in 8MHz RC oscillator calibrated by the factory
− Built-in 40kHz RC oscillator with calibration
− PLL that generates the CPU clock
− 32kHz RTC oscillator with calibration function
l Low power consumption
− Sleep, shutdown and standby modes
− V BAT powers RTC and backup registers
l2 12-bit analog-to-digital converters, 1us conversion time (up to 16
− Conversion range: 0 to 3.6V
− Double sample and hold function
− Temperature sensor
lDMA:
− 7-channel DMA controller
− Supported peripherals: timer, ADC, SPI, I 2 C and
USART
l Up to 80 fast I / O ports
− 26/37/51/80 I / O ports, all I / O ports can be mapped to
16 external interrupts; almost all ports can tolerate 5V signals
number
l Debug mode
− Serial single wire debug (SWD) and JTAG interface
l Up to 7 timers
− 3 16-bit timers, each timer has up to 4
Input capture / output compare / PWM or pulse counting channels
And incremental encoder input
− 1 16-bit control with dead zone and emergency brake for motor
Controlled PWM advanced control timer
− 2 watchdog timers (independent and window type)
− System time timer: 24-bit self-decrementing counter
l Up to 9 communication interfaces
− Up to 2 I 2 C interfaces (support SMBus / PMBus)
− Up to 3 USART interfaces (supports ISO7816 interface,
LIN, IrDA interface and modem control)
Up to 2 SPI interfaces (18M bits / sec)
− CAN interface (2.0B active)
− USB 2.0 full speed interface
lCRC calculation unit, 96-bit unique chip code
feedback Report comment