PC817 3.6-30V 2 Channel Optocoupler Isolation Board Voltage Converter Adapter Module Driver Photoelectric Isolated Module 817
zoom_out_map
chevron_left chevron_right

Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.

Produsul este destinat specialistilor si nu include instructiuni de asamblare/utilizare. Produsul beneficiaza de garantia legala de conformitate (produsul este conform specificatiilor din site) egala cu durata de functionare medie a produsului de 14 zile de la data primirii produsului si de garantia Dead on Arrival (nefunctional la primire).

PC817 3.6-30V 2 Channel Optocoupler Isolation Board Voltage Converter Adapter Module Driver Photoelectric Isolated Module 817

22.26 RON Tax included 18.71 RON (tax excl.)
Tax included

Specificatii:

It can realize 3.3V or 5V control 3.3---30V voltage level interface, after the control

terminal input high level is turned on, the controlled terminal will also conduct to

the ground, and the port changes from the original high level to the low level. For

the friend of the single-chip or PLC, it is only necessary to judge when the output

port is low.

 

The photoelectric isolation has strong anti-interference ability, and the

combination control of many different devices can be realized later, such as triode,

MOS tube, and small power relay module.

 

If it is a pulse signal, please note that the limit of 817 is below 3KHZ. If the control

signal is greater than 3KHZ, please do not use this module, it will not work properly.

 

 

Parameter:

 

1, the drive terminal signal voltage: 3.3-24V

 

2, the output voltage range: 3.3-30V (output current depends on the specific

situation, but the maximum is not 10MA, the total power is certain, the voltage and

current are inversely proportional)

 

3, through the jumper cap can achieve whether the output is high potential output

or low output.

 

4, the board above 2 / 4 817 are independent, can achieve simultaneous control of

different voltages, etc.

 

5: board size: length: 48mm; width: 38mm; long side hole distance: 42mm; wide

side hole distance: 32mm

chat Recenzii (0)