Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.
Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.
Holybro radio telemetry set, 433mhz, 100mW
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
Holybro SiK telemetry set that operates at a frequency of 433MHz, with a maximum power of 100mW. This is an open-source, compact and lightweight radio platform that facilitates bidirectional communication between the drone's autopilot and the base station on the ground. It offers a plug-and-play connection for compatible Pixhawk Standard flight controllers and other types of controllers, being easy to configure for remote monitoring and control.
The module uses SiK open-source firmware, specially designed to work efficiently with MAVLink packages and to integrate perfectly with software such as Mission Planner, Ardupilot, QGroundControl and PX4 Autopilot.
It has a maximum output power of 100 mW and a reception sensitivity of -117 dBm, this telemetry set allows a range of over 300 meters "out of the box", and with a patch antenna, this distance can be significantly extended .
Features:
SiK open-source firmware
Plug-and-play compatible with Pixhawk Standard flight controllers
Easy connection between the autopilot and the ground station
Interchangeable radio for air and ground
Micro-USB port with Type-C adapter included
JST-GH 6-pin connector for Pixhawk and other controllers
Bidirectional full-duplex communication through adaptive UART TDM
Support for MAVLink protocol and frequency spectrum FHSS (Frequency Hopping Spread Spectrum)
Error correction for up to 25% of bit errors
Specifications:
Supply voltage: 5V DC (via USB or JST-GH)
Transmission current: 100 mA at 20 dBm
Current in reception: 25 mA
Maximum output power: 100 mW (adjustable)
Reception sensitivity: -117 dBm
RP-SMA connector for antenna
Serial interface: 3.3 V UART
Dimensions: 28 x 53 x 10.7 mm (without antenna)
Weight: 20.7 g (433MHz version)
Package Contents:
2 x Radio modules with antennas (433MHz)
1 x Micro-USB to USB-A Cable
1 x Micro-USB to Micro-USB OTG Adapter
1 x Micro-USB to Type-C Adapter
1 x JST-GH-6P to JST-GH-6P Cable (for Pixhawk Standard)
1 x JST-GH-6P to Molex DF13 6P Cable (for Pix32, Pixhawk 2.4.6, etc.)
