# 5-12V ZVS induction heating module

> ZVS induction heating module for DIY projects, testing and rapid heating of small metal parts. Operates at 5-12V, with a maximum power of 150W at 12V (a 10A power supply is recommended). Features a blue LED for power indication, and the coil is recommended to be soldered directly onto the PCB for stable electrical contact.

- Page: https://sigmanortec.ro/en/5-12v-zvs-induction-heating-module
- Price: 46.79 RON
- Availability: In stock; 1-2 zile
- Reference: 33171 · EAN: 5943509977037
- Category: Electronic components > ZVS module
- Specifications: tension: AD; Supply Voltage: 5; Maximum Input Voltage: 12
- Package (shipping data): 0.114 kg
- Updated: 2026-06-12
- Shop: [Sigmanortec.ro](https://sigmanortec.ro/en/llms.txt)
- Prices: RON, VAT included; prices and stock as of 2026-10-22 03:25 (Europe/Bucharest)

## Description

ZVS induction heating module for DIY projects, testing and fast heating of small metal parts. It operates at 5-12V and can deliver up to 150W at 12V with a 10A source, has a blue LED for power indication and a coil recommended for direct soldering to PCB for stable electrical contact.
Induction heating module 5-12V ZVS
Maximum power: 150W at 12V (pay attention to overheating)
At 12V, a 10A power supply is recommended
Avoid powering directly from a 12V battery.
Make sure everything is properly connected before powering on. The coil is recommended to be soldered directly to the PCB.
WARNING! The module can easily burn out if used incorrectly, so we do not take responsibility for any damage resulting from its use.
Manufacturer's note:
When using battery and battery power supply, it must be ensured that the working voltage is above 4.5V! Do not ensure that the voltage is always above 4.5V during operation, do not use battery or battery power supply! Do not use dry battery power!
The width of the heated object should be between 1/3 and 1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3!
The diameter of the heated object should be controlled within 20mm as much as possible. If the heating is too large, it will be difficult to heat up to red. After all, the power is limited.
Inductive heating, usually work for 5 minutes to power off cooling. Because the current is relatively large during induction heating, the coil heat is also relatively large. When heated, part of the heat generated by the heated object is transmitted to the heating coil. For a long time, the temperature of the heating coil is high. If the heating coil is connected to the terminal, the plastic part of the terminal will be melted! Therefore, it is best to solder the heating coil directly to the PCB during induction heating.
For long-term use, it is recommended to use a copper tube as a coil and cool it with water.
Blue LED power indicator, there is no electricity, you can see if the light is off!