# Motor driver module, dual H-bridge, DRV8833, 1.5A

> Motor driver module with dual H-bridge based on DRV8833, for controlling a 4-wire stepper motor or two independent DC motors. Provides separate PWM control per channel, 1.5A current per motor, 3-10VDC supply voltage, protection against overcurrent, short circuit, undervoltage and temperature, plus a sleep mode for reduced power consumption. Dimensions: 18.5 x 16mm. Compatible with Arduino and other development boards.

- Page: https://sigmanortec.ro/en/motor-driver-module-dual-h-bridge-drv8833-15a
- Price: 6.52 RON
- Availability: In stock; 1-2 zile
- Reference: 9380 · EAN: 5944304781621
- Category: Mechatronics and IoT > Driving Motor
- Specifications: Nominal Current: 1.5 A
- Package (shipping data): 0.002 kg
- Updated: 2026-09-14
- Shop: [Sigmanortec.ro](https://sigmanortec.ro/en/llms.txt)
- Prices: RON, VAT included; prices and stock as of 2026-10-22 01:46 (Europe/Bucharest)

## Description

Compact dual H-bridge driver based on DRV8833 for controlling one 4-wire stepper motor or two independent DC motors, ideal for Arduino and other development boards. Offers separate PWM control on each channel, 1.5A per motor at 3-10V, overcurrent, short circuit, undervoltage and temperature protection, plus sleep mode for low power consumption.
Motor driver module, compatible with Arduino and other development boards, which uses the integrated DRV8833 which can drive a 4-wire stepper motor or two independent DC motors by using the dual H-bridge, with the help of a PWM signal for each motor separately.
It has protection against current, short circuit, low voltage and temperature. There is also a sleep mode that offers reduced energy consumption.
Specifications:
Supply voltage: 3 - 10VDC
Output current per motor: 1.5A, 2 motors
Dimensions mm: 18.5 x 16mm
Pinouts:
ULT: set to LOW enters sleep mode
OUT1, OUT2: channel 1 H-bridge controlled by IN1 and IN2
OUT3, OUT4: channel 2 H-bridge controlled by IN3 and IN4
EEP PIN: Output protection
VDC: 3-10VDC
GND: GND
Important : Bringing the IN pins of the same channel to the HIGH level together will burn the module!
In order to be able to set the sleep mode, it is necessary to remove the jumper J2. It is possible that it should be short to avoid entering the default sleep mode.